Looking for some great tips for installing DaVinci polymer roofing tiles? People always ask me for tried-and-true hints for better installation. So, here are a few key points to keep in mind:
#1 – Install snowguards during the roof installation rather than retrofitting them later. It's easier to get snowguards in place when the DaVinci roof tiles are initially installed than going back in a year or two and fitting them in place.
#2 – Be careful with your chalk lines. Blue chalk is probably the better choice over red or black (red chalk will almost certainly permanently stain our tiles). When it says "permanent chalk" on the bottle, you should believe it. And the big hint when installing DaVinci composite roofing tiles in a staggered application is to snap lines on the underlayment and then lay the tips of the tiles to those lines rather than marking the synthetic roofing materials.
#3 – Try using a rake tile on gable ends when installing the Bellaforté Shake products. It makes these luxury roof tiles easier to install because you don't need to be too concerned with how precise your cuts are on the gable end — the rake tile covers up all the cuts. And, if you install the rake tile with the optional screw in the butt of the tile (on the fascia side) you will definitely enhance wind performance.
#4 – Avoid wasteful tile cuts for valleys by finding the correct angle and then cutting your polymer tiles with a circular saw. Then use all the accurate valley cuts and use the leftovers to finish the hips.
#5 – Nail DaVinci steep slope roofing tiles with copper, stainless steel, or hot-dipped galvanized nails during installation. The reason for this recommendation is that we expect our synthetic roofing tiles to last for a very long time (yes, a 50-year roof is what we hope every project achieves!) and we don’t want the fasteners to rust, become ineffective, and be the mode of failure of the Class A Fired Rated roofing system.